This setup guide is intended for laptops running Alpine Linux.

First step, remove your wifi interface from /etc/network/interfaces. Make sure networking is enabled via rc-update, otherwise you wont get a configured loopback device..

# Install necessary stuff
apk add wpa_supplicant dhcpcd

# Enable services
rc-update add wpa_supplicant
rc-update add dhcpcd

# Start dhcpcd now
/etc/init.d/dhcpcd start

Create your wifi config snippet with wpa_passphrase and append it to /etc/wpa_supplicant/wpa_supplicant.conf. I found it necessary to keep the settings for the control socket in there:


Each network section should look like this:

	ssid="Abraham Linksys"
	# priority=4

The priority field is optional, but if you have multiple network sections, it can be useful to have an explict preference order. Higher number means higher priority.

Start wpa_supplicant with /etc/init.d/wpa_supplicant start. You can check if the connect was succesful by entering the wpa_cli shell and typing status. The wpa_cli is also useful for dynamically connecting to wifi without having to permanently save it in wpa_supplicant.conf.

If wpa_supplicant is successful, dhcpcd will automatically recognize the now up network device and configure it via DHCP.